Calibration Cube Review and Feedback



  • I've got a material (PETG + CF) That's i've been messing with for a while now.. you'll see some of the defects in the cube, looking for feedback as to what to clean up next.. dimensionally I've got flow etc all dialed in perfectly but... the corners and top and bottom layers bulge then there is almost some weird ghosting on the rear corner of the xy asis where you can see shifts at the same height(s) as the lower leg of the Y but on the corner.

    1_1667246216358_IMG_5067.jpeg 0_1667246216358_IMG_5068.jpeg



  • Looking at the layers in the slicer these are largely happening at retraction points of course.



  • This post is deleted!

Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.