Subcategories

• Ultimaker
  14
  Topics
  41
  Posts
  No new posts.
• Raise3D
  3
  Topics
  11
  Posts
  No new posts.
• BCN3D
  6
  Topics
  14
  Posts

  M

  Last week I went to use the BCN3D cloud to upload a part and remotely start my Epsilon W50 and the cloud site was down. I went to check today and the entire site is down- not just the cloud site. I also noticed that it is getting increasingly difficult to find hotends in stock and bcn3d filament. Am I mistaken or is BCN3D shutting down? I googled it and I haven't found any announcements or emails announcing this. What is going on?

• LulzBot
  13
  Topics
  27
  Posts

  S

  In answer to my own question...

  While attempting to hot tighten, I had the parts laid out and plugged in, but not assembled inside the print head when I got the error.

  In desperation, I assembled the print head on the printer, and then started up printer. Found Home, raised the print head 60mm and over on the X axis until I could fit the wrench (about 150mm or so). I raised the temperature and no error thus far.

  Lesson learned, hot tighten on the TAZ 5 fully assembled.