these two problems have just occurred.
1) i am getting a box come up at the start telling me turn on location, how can I get rid of it.
2) this is the most annoying, suddenly the small USB connection is playing up. I normally use this to upload models, .
when it does upload one it disconnects, and will not reconnect, until I remove the usb addapter..then all works fine.
Never had these problems before.
I have never tried this, but am assuming it is possible.
I have only one extruder.
If I pause this what happens does the filament stop extruding /
How long do I get to make the change?
Can I tell it in the start gcode at what layer to pause at, or is it done elsewhere/
I have sorted the probe problem, it seems it did not like two statements at the head of the start gcode, namely
M10y64 S and M104 S, removing these solved the problem.
Other problems are with the support, these do not break away very well, they were ok before this update.
Also fixed in the earlier update, the bluetooth Keyboard, does not work in this later version.
Also mention earkier opening files in the cloud, does not work on the T10, but ok on the desktop computer.
The next two problems are most likely settings, so if someone could give me an idea it would be great.
Flat surfaces on the bed print very rough, walls are fine.
Printing tube, the bottom few layers swell out to a height of around 3 mm.
Tried to load the gcode file as a zip file but it did not work, so will send it via email.
It has been 10days since I got a reply, the problems previously mentioned still apply, but there are a couple more.
1) I am printing and open box, the flat area is very very course, while the sides print just right, any ideas why this is so, I have a .2 layer height.
2) I am printing some tubes and the bottom few layers are swelling out.
When I said I had got the files to print, that was via the Library on the T10 itself, I tried the cloud again this morning and that is still a problem, and it goes for all files not just the ones previously mentioned.
I still need some info on support settings, it is just not working for me, before the update things were reasonable, but since, for want of a better word they are crap.
Another problem that has been ongoing is that holes are printed smaller that the programed size, now this is not just a fact of Matter Control, but with most programs I have tried, even S3D has the same problem.
Anyway of getting this corrected..
Apart from all these little problems I am having, Matter Control in my opinian is the best.
In the cloud library under purchased products there is file called.
Make Magazine digital fabrication shootout models, which has 10 test models, when I try to print them I get the message Oops ! unable to print please try again later.
Regarding going to previous version to test the probe, is this going to change all the resetting I have just done. Cheers Ernie
I have since worked out the print problem.
Another question, regarding support.
When I put a perimeter around a support there is some difficulty in removing it, and it puts 3 layers on top the last one of these remains on the model, what settings should I use here?
Followers 0 Following 0 Joined Last Online