Pull out on pause?
-
Is there some way to have the machine pull up automatically when the print job is paused?
When I've had to pause a print for whatever reason it keeps cooking the print before I can pull it out.
-
You can configure any set of commands to be run during pause by inserting them into the Pause G-Code field: http://wiki.mattercontrol.com/SETTINGS/Printer/Custom_G-Code/Pause_G-Code
See here for a reference to G-Code commands: G-code - RepRap
-
Tidy, thank you.
The only problem I see there is that that code assumes that the printer was in absolute addressing when it is paused: that may not be the case. Is there any way to check?
-
MatterControl always runs in absolute mode, even if relative is specified.