bed leveling wizard not centered
-
I'm using the 7 point leveling "wizard" and first few go fine, but when get to the first point left on bed it is about 8mm off the bed to the left. I might say that the entire thing is 8mm off. What is the best way to configure the printer or software to put center on center?
-
It sounds like you might need to adjust the Bed Size setting before you run the leveling wizard. You can always change it back after the wizard.
http://wiki.mattercontrol.com/SETTINGS/Printer/Print_Area/Size_and_Coordinates/Bed_Size
-
Thanks. Seems like it used to be fine, but for some reason became "off". I "fixed" it by using offsets, and reducing bed size a little.