ATX Power Control. Turn on your printer remotely, and turn off when finished.
When will the ATX Power Control be implemented?.
I have enabled the "Has Power Control", but the button will never appear in the control pane, as stated in the help text!
I can turn on the printer with the M80 command and turn it off again with the M81 command in the console, but it will be very handy with a specific button.
I've setup the M80 command in the "start gcode" section, and the printer turns on automatically when i start a print remotely.
And i've setup the M81 command in the "end gcode" section, and the printer turns off when the print is done. Very handy.
These controls are available in the desktop version of MatterControl, just not on the MatterControl Touch. We are aware of this and it is on the todo list. However, it will have to wait until after the release of version 1.6, which is coming out in a few days. You can always add a macro for the