"Infill Type" Setting Missing?
-
I am using MatterControl 1.5 with my Robo 3d Printer. I set Fill Density to 1 and when I start to print I see a dialog saying I should change the Infill Type and where to find this setting. However, the only setting I have under "Infill" is Fill Density. I am looking at advanced settings so am I missing something?
-
It sounds like you're using CuraEngine as the slice engine, and there seems to be some flawed logic with the error message that's appearing for infill.
I'll make a bug report for it so the dev team can address it; in the meantime I suggest either switching to MatterSlice so you can use LINES as the infill type or using a lower infill density with CuraEngine.
