Not necessarily a problem - wanted to be sure I wasn't seeing some kind of firmware or MC error. Loaded Repetier v92 and all seems to behave as expected now.
G-Code is generated for a specific printer based on configuration settings, so usually it's meant to be used for just that one printer.
You can use the Other -> Other (Make -> Model) profile to start a new profile for a model that does not yet have a profile. Check this list for the minimum settings to configure for a new printer: http://wiki.mattercontrol.com/Custom_Printer_Profiles#Edit_printer_settings
If you can't connect with either MatterControl or Cura, then the problem is most likely with the board. We've seen this occasionally with Robo printers; contact their tech support for a replacement board.
You may only upload PNG, JPG, or GIF files ()